Curtis Dyna-Fog TWISTER XL 3 3950, Инструкция по установке, эксплуатации и техническому обслуживанию

Страница: 8 / 61

8
Pre-Spray Checklist
1. Verify that the operator came easily find and operate the engine kill switch, to stop
the machine, or allow it run.
2. Verify that the steam of the formulation (spray) ON/OFF valve is easy to rotate, to
open and close the valve, remaining in off position.
3. Verify that the engine has sufficient gasoline. If your Twister unit came with Tanaka
engine make sure the gasoline was properly mixed with 2-cycle oil.
4. Verify that the air inlet filter of the blower is clean and unrestricted.
5. Inspect all hoses for abnormal conditions.
6. Verify that no foreign objects and tools have been left in or about the machine.
7. Verify that the sufficient amount of formulation is in the tank and that the tank filling
cap is tight and air vent hole is not restricted.
8. Verify that the formulation line at the machine includes the appropriate flow control
orifice for the viscosity and recommended flow rate of the formulation intended to
dispense, in accordance with the manufactures label requirements.
9. Verify that the belt is in the right position on the sheave,
10. Verify the sight position of straps and belts on the frame before use the machine.
11. Verify that all safety equipment is in place and is in proper working order.
CAUTION
BEFORE PROCEEDING WITH ANY SPRAYING OPERATION, THE OPERATOR
SHOULD BE THOROUGHLY FAMILIAR WITH STARTING AND STOPPING THE
MACHINE WITH ALL THE OPERATING CONTROLS. IF YOU ARE OPERATING THE
MACHINE FOR THE FIRST TIME, EXERCISE THE MACHINE THROUGH ITS FULL
OPERATIONAL SEQUENCES FROM A POSITION OF FULL VISIBILITY OF THE
MACHINE BEFORE OPERATING THE MACHINE ON YOUR BACK. THIS IS ALSO A
GOOD IDEA FOR EXPERIENCED OPERATORS WHO MAY BE OPERATING A NEW
MACHINE OR WHO MAY BE REACTIVATING A MACHINE AFTER REPAIRS OR A
PERIOD INACTIVITY. REFER TO THE ENGINE SECTION FOR STARTING AND
STOPPING INSTRUCTIONS.