Curtis Dyna-Fog MAXI-PRO 2D ULV, Инструкция по эксплуатации и техническому обслуживанию

Страница: 20 / 52

20
To measure the flow ability (viscosity) of your formulation:
1. Place a sample of the formulation liquid to be dispensed in the relative viscosity
meter provided with the machine such that the liquid level is above the top line.
2. Hold the meter vertical and allow the liquid to flow through the brass orifice at the
outlet end of the meter into an appropriate container.
3. Using a stopwatch or a watch with a sweep second hand, determine the flow
ability time in seconds that it takes for the liquid level to fall from the top line to the
bottom line.
Once the flow ability of the liquid has been measured, tables 1 and 2 can be used as an
approximate guide for setting the pump flow rate and nozzle boom pressure for your
spray application.
NOTE: Periodically calibrate the flow ability meter using plain water. Water should flow
through the orifice such that the time between the top line and the bottom line is
32 + 2 seconds.
CAUTION
Follow all warnings and cautions on your formulation label. Do not attempt to
apply any formulation at a rate greater than what is specified on the formulation
label. This includes driving your vehicle at a rate slower than what is specified.