Curtis Dyna-Fog MAXI-PRO 2D ULV, Инструкция по эксплуатации и техническому обслуживанию

Страница: 10 / 52

10
ASSEMBLY INSTRUCTIONS
1) Uncrate the unit and remove all packing materials.
NOTE : It is a good idea to retain the original machine shipping carton for storage.
2) Place the remote control unit where it will not be damaged while the machine is
being installed.
3) Remove the machine from the shipping skid by removing the three lag screws
that retain the shipping brackets. Keep the brackets for mounting the machine to
your vehicle or trailer bed.
4) Check the lubricating oil level in both the engine and blower. Refer the engine
and blower sections of this manual and to the engine and blower manuals for the
correct filling procedure and add oil if necessary.
5) Activate the dry charge storage battery according to the following instructions:
CHARGING THE BATTERY
DANGER: POISON
Batteries produce explosive gases. Keep sparks, flame and cigarettes away!
Ventilate when charging or using in an enclosed space.
The battery contains Sulfuric Acid, which causes severe burns. If acid contacts
eyes, skin or clothing, flush well with water. For contact with eyes, get immediate
medical attention.
Keep battery and acid away from children and other persons who may not be
aware of dangers involved.
A. Remove battery from its mounting and place on a stable workbench.
B. Remove vent caps from battery. Remove or destroy any sealing device which
may have been used to close or restrict the vent openings in the vent caps.
C. Fill each cell of the battery to the top of the separators with approved battery
electrolytes of 1.265 specific gravity.
NOTE: The temperature of the battery and electrolyte at time of filling should be above
60
0
F. (15
0
C).