18
STARTING THE ENGINE
1. CHOKE ENGINE:
Move engine choke control to position lever in "choke" position
(pulling the control rod). NOTE: This should fully close
choke on carburetor.
Note: The manual choke is provided for cold
starting of the engine. Once the engine has been
allowed to warm-up, choking the engine should
not be needed for restarting.
2. TURN "ON" THE MACHINE "ON/OFF" SWITCH:
Position Machine "ON/OFF"
switch on the remote control box to "ON" position.
Also verify that the "OUTPUT" switch on the remote
control box is in the "OFF" position.
3. TURN "ON" (RUN) THE "RUN/STOP" SWITCH:
Position the kill switch on engine to "ON"
.
This switch
is located next to the starter button.
4. START ENGINE:
Activate the spring-loaded starter switch on the engine or activate
the toggle switch on the remote control box to the start position. NOTE: To
prevent overheating the engine starter motor, do not act
i
vate the motor longer
than 15 seconds at a time.
5. SET ENGINE SPEED:
Allow the engine to warm-up
and gradually move the choke lever to the "un-
choked" position (pushing the control rod).
Adjust the engine Speed control to achieve the
desired Boom Pressure, by pulling the control rod
to increase the engine speed (increase the boom
pressure).
The engine speed control is located close to the
cap of the oil level indicator (dipstick).
Содержание MAXI-PRO 2D ULV
