you are not confident that the brakes are working properly.
•
Using the Axle Release™ Quick-Release Adapters (rear
wheel)
See referenced figures on the next page.
INSTALLATION: Position bicycle upside down. Using a wrench,
remove and dispose of the threaded securing nut from one
side of the axle if applicable (see ‘A’). Retain any safety
washers in place . If the bicycle comes equipped with the
axle release; disregard step A. While holding the spacer
snugly to the assembly, grasp such assembly with the lever in
an open position . Place the threaded opening against the
end of the axle and spin it slowly in a clockwise motion . While
doing so, apply light pressure until contact is made against
the bicycle frame by the spacer- (see ‘B’) . (If the lever
assembly does not thread on smoothly or appears to be the
wrong size, STOP! Reposition the device and restart . While
gripping the bicycle firmly, close the lever to its fully closed
position (see ‘C’-‘D’) . If the lever closes without resistance,
reopen lever, spin the assembly further clockwise and reclose
until firm and secure connection is found. Repeat processes
for both sides of each wheel . Note: Do not perform this
installation for both sides of the axle concurrently as axle may
rotate. Always ensure proper installation prior to use by lifting
the bicycle frame off the ground . While holding, strike the top
of the inflated rubber tire with a few sharp blows. Sample test
is good indication but does not guarantee proper installation
has occurred .
UNDESIRABLE LEVER POSITIONS: If lever is in an undesirable
closed position on the wheel (undesirable on front: forward
or down, undesirable on rear: up or down), reopen lever,
and unthread using counter-clockwise spinning motion
until assembly is removed . Remove the spacer from
assembly (see ‘E’) . Each washer (labeled 90, 180, or 270) will
progressively add around 90 degrees of counter-clockwise
turn to the final handle position. Carefully select a washer
p .
49
/52
Содержание eFlow E3Nitro
Страница 52: ......
