ALP48 Programming Manual
Page 6 of 6
©2009 Current Thinking Ltd
User Level Menu
For the user menu, the following menu items are available. (Some items may not
be shown depending on system configuration and status. These will be described
in the appropriate section.)
Accept faults
If the buzzer is sounding, pressing [A] will accept the fault and silence the buzzer.
When the buzzer is silenced, it will emit a single beep once every 15 seconds to
indicate the system is still in fault.
This menu option is only shown when the buzzer is sounding in a cadence, and
Mute Buzzer
is enabled in the
Setup
menu described later.
View audio sources
This is a diagnostic display showing the current audio routing of all configured
DCA4s on the network. Each page shows up to 4 DCAs.
Press (R> to scroll forward through the pages;
Press <L) to scroll backward through the pages;
Press [A] to exit this menu.
Each line will show the address number for that DCA4 along with the audio input
for all 4 outputs. Each audio input has a 3 letter designation. If this DCA4 is not
detected on the network, then
Not detected
will be shown on this line.
1: BGM BGM BGM BGM
2: - - - -
3: Not detected
4: Evc Alt Alt Alt
Audio input designation
Each audio input has a specific 3 letter designation. The only configurable
designations are for the 6 messages (see later).
' - '
No audio input
'FM ' Fire microphone
'Dat' Data microphone
'Hi '
High priority microphone
‘Tst’
Default for Message 1 on Store 1, configurable
‘Sec’ Default for Message 2 on Store 1, configurable
‘Evc’
Default for Message 3 on Store 1, configurable
‘Clr’
Default for Message 1 on Store 2, configurable
‘Stf’
Default for Message 2 on Store 2, configurable
ALP v3.8-User
Back
>View audio sources
View fault status
Accept faults
Log in
