22
23
Reflection Plate and Diffuser
The flash unit has an integrated reflection plate
and a diffuser. You can slide out the reflection
plate or the diffuser on the upper side, swivel the
flash head and use the reflection plate to shoot
photos with a heavy effect. The diffuser can
reduce the strong light, creating soft effects.
Using the diffuser is recommended to achieve
ideal results at close proximity (1 – 3 yards).
Energy-Saving Function
To save electricity, the flash unit automatically
switches off approximately 3 minutes after it has
been switched on or since the most recent flash
was released. The LCD display indicates the
“OFF” signal. To reactivate the flash unit, simply
press any button switch below the LCD display
table or switch the main switch off and back on.
The flash unit is not full switched off in the
energy-saving function setting, but its energy use
is drastically reduced. When you are no longer
using the flash unit, set the main switch to “OFF”.
ENG
ENG
Power-Zoom
Automatic control of the motorized zoom
When using zoom lenses that transmit their focal
widths to the camera, the camera forwards this
information to the flash unit. Then the flash unit
automatically adjusts its zoom position. The
automatic reflector control of the motorized zoom
is possible with cameras that permit the digital
transmission to the flash unit.
The LCD display on the flash unit indicates zoom
positions of 24-28-35-50-70-85 mm. When the
flash unit is switched on, the zoom is activated
and the position is set at 35 mm. As soon as the
camera’s release is touched only slightly, the focal
width of the flash unit is automatically adapted to
the focal width of the lens.
Whenever the flash head is not at the normal set-
ting (pointing forwards) whereby it is in another
position, the zoom position clicks to 50 mm and
is indicated in the LCD display by a short flash in
the Auto mode.
Manual Control of the Motorized Zoom
With the “Zoom” button, you can alter the
reflector position of the zoom independently
of the focal width of the lens. The LCD display
then indicates “M” and the current setting of the
reflector’s zoom position.
Light tapping of the “Zoom” button changes the
zoom position in this order: 24-28-35-50-70-85 mm.
Receiver Function
This flash unit can be operated as a wireless re-
ceiver by setting the switch “Slave Mode” to the
S position. The flash unit switches automatically
to the M mode with an energy ration of 1:1 and a
focal width of 24 mm. When the sensor discovers
the release of an extreme flash, the flash is
released simultaneously. The quantity of the light
emission can be selected by setting the energy
ration from 1/1 to 1/8. If several flash units
are used as receivers, then the corresponding
quantity of light must be taken into consideration
in order to calculate the correct lighting. If the
reception mode is activated, the energy-saving
mode does not operate.
