CUBICON Single Plus
User Manual
48
The extruder gear can be rotated with D-gear of motion by turning the power ON in the extruder pullout condition.
Make sure to rotate the gear pressing handle. In the case of cleaning with air compressor, quality decrease
and equipment malfunction may occur due to powder insert to shaft.
* Make sure to rotate the gear by pressing handle in the process of the gear cleaning. The gear
abrasion may occur in the case of moving the gear without pressing handle.
* Be mindful that equipment malfunction might be caused due to powder insert to the shaft in the air
cleaning process.
* Do not put conductive materials into cleaning part during the printer power is ON. It may cause
equipment shock.
(2)
Cleaning of filament channel contaminants
Basically, the extruder, which uses all provided material or mixes all materials are not recommended.
Filaments have different property and temperature. Those differences may be accumulated slowly and they
may cause serious problems. Even though the inside filament can be deleted in the time of using ABS during
PLA use period, PLA ingredient may remain on a wall surface. Those filament leftovers are accumulated
continuously and sometime they cause printing failure due to nozzle blockage (
Below picture shows the
phenomenon, which is caused by the filament mix.)
