CUBICON Single Plus
User Manual
14
5-3. Filament installation
① You can open by pushing back a spool door handle of
the printer body.
② Slowly release the filament from filament spool and
push the filament into filament insert hole
* be careful of the
rotation direction
③ Open the top door and push in the filament until it
comes out of Teflon tube entrance
④ Insert the filament spool into filament bar and fix spool by
closing the spool door pressing handle until you hear clicker.
* Filament spool has its own direction
(Install the spool, make sure that company logo or the product sticker
side is visible from outside)
*Any interruption between filament bar and the spool, in the process of the filament spool installation, may
cause the printer malfunction as it raise the problem in a filament supply.
Make sure to remove an obstacle,
which causes interruption to rotation in the spool insert process.
Make sure to remove a spool package
included silica gel from inside spool.
*
A teflon tube is the channel from the filament spool to the extruder
.
if the tube is pulled with exteme power,
tube breaking, or tube twisting may occur and it may cause abnormal filament operation and malfunction as
the teflon tube length is optimised to the printer. Do not break, cut or pull installed teflon tube with extreme
power.
