CTM HS-268, Руководство по обслуживанию

Страница: 68 / 68

66
100+-10kgf-cm
100+-10kgf-cm
SERVICE - 13 - 7
Linear Actuator Repair :
Please refer to SERVICE-13-6 Sliding Base Repair.
1.The linear actuator and sliding base fastening point is located at the side of the top end
of the gas spring.
2.Use an Allen driver (#5) to remove the holding screw (40mm, 1pc).
3.The linear actuator can then be separated from the sliding base.
※
When replacing the unit, follow the same sequence of steps in reverse.
SERVICE - 13 - 8
Gas Spring Repair: ( manual version only )
Please carry out the SERVICE-13 Frame Repair SERVICE-13-1 Folding Unit Repair
SERVICE-13-2 Sliding Track Repair SERVICE-13-6 Sliding Base Repair steps and then :
1.Locate the gas spring and sliding base at the top end of the gas spring.
2.Use an Allen driver (#5) to remove the holding screw (40mm, 1pc).
3.The gas spring can then be separated from the sliding base.
※
When replacing the rod, follow the same sequence of steps in reverse.
※
To install a new gas spring, the rubber sleeve on top of the gas spring needs to be
removed to prevent abnormal actuation during folding or unfolding.
*Subject to change without notice.
( Rev. 0, 2019/08/20 )