CTM HS-268, Руководство по обслуживанию

Страница: 62 / 68

60
70+-7kgf-cm 0+-7kgf-cm
SERVICE - 13 - 1
Solenoid Valve Repair :
Please refer to SERVICE-12 Rear Lower Cover Repair steps
first, then :
※
Find the left and right -solenoid valve wiring inside the lower cover.
※
Check the connections and re-connect the wires if necessary.
※
If this does not restore function refer to the following “Solenoid
Valve Replacement”.
Solenoid Valve Replacement :
Please remove the connectors.
1&2.Use an open wrench (#21) to loosen the valves.
3.Take them out.
※
When replacing the valves follow the “Re-installation Instructions” below and carry out
the “Re-installation Test”.
Re-installation Instructions :
※
Before re-installation, apply a little gel to the threads on the valve
to ensure they do not come loose, see the picture on the right.
※
Be careful not to get any gel on the plunger because this will
cause a malfunction.
※
During re-installation be careful to ensure the threaded portion
goes in straight and the solenoid is tightened properly in place.
Re-installation Test :
※
Turn on the power and allow the scooter to perform a folding → deployment action.
1.Make a mark 19mm from the end of a short rod, see the picture on the right.
2.Remove the circular stickers on each side of the scooter frame, see picture.
3.Insert the probe into the hole on each side of the frame.
4.If the rod does not go past the 19mm mark the installation has been successful.
※
Replace the stickers to prevent water getting into the holes.