CTM HS-268, Руководство по обслуживанию

Страница: 59 / 68

57
•
Set the four screws and the remote control board main cable aside carefully
because these parts are not included with a new board.
•
When making the installation be careful not to damage the terminal on the
control board.
•
After the remote control board has been replaced, the RF remote controller
that came with the scooter will need to be set up again.
Refer to the SERVICE-12-2 Remote Control Board Repair steps, then :
1.Detach the battery connectors from the hooks on the rear lower cover.
2.Remove the connectors from the remote control board.
3.Remove the remote control board main cable.
4.Remove the four screws (8mm, 4pcs) holding the remote control board in place.
5.Take the remote control board out.
※
When reinstalling, carry out these steps in the exact reverse sequence.
※
If function is not restored refer to SERVICE-11-1 DR Controller Repair to replace it
with a new one.
Remote Control Board Replacement