CTM HS-268, Руководство по обслуживанию

Страница: 63 / 68

61
70+-7kgf-cm
SERVICE - 13 - 2
Folding Unit Repair (manual only)
•
With the scooter upright on an even surface confirm that it operates properly
and does not jerk or skip.
•
If the folding unit steel cable has been damaged, please replace it with a
new one.
•
Make sure to secure the folding unit cable to the frame with a new cable tie
to ensure it is safe and secure.
Carry out all the SERVICE-11 Rear Top Cover Repair SERVICE-12 Rear Lower Cover
Repair SERVICE-11-5 Rear Fender Repair steps, and when this has been done, then :
1.Locate the folding unit locking pins on each side of the bottom of the scooter frame.
2.Use a wrench (#17) to remove the locking pins.
3.Cut and remove the cable tie (x1pc) on the frame and remove the steel cable.
4.Use a cross-head screwdriver to remove the screws (12mm, 2pcs) from the plastic shroud.
5.Use a cross-head screwdriver to remove the screws (20mm, 2pcs) that hold the folding unit.
6.Take out the entire folding unit set.
※
When replacing parts or re-installing, carry out these steps in the exact reverse sequence
but also follow the re-installation instructions below.
Re-installation Instructions :
For the folding unit re-installation cable wiring, please refer to the pictures on the right
- pay particular attention to the items shown in triangles.
Cable wiring needs to pass through the
middle of the motor.
The right folding unit locking pin (shorter
steel cable) passes inside the sliding
base.
The left folding unit locking pin (longer
steel cable) passes outside the sliding
base.
A cable tie is necessary to hold the
cable in place.