CTM 360a series, Руководство по техническому обслуживанию и ремонту

Страница: 35 / 176

360a DISPLAY
3-23
CONFIGURATION SETUP (cont’d)
(CROSSOVER OPTION)
The Secondary has a new button that if this
Applicator is active, you can transfer the
labeling back to the Primary with less chance
of missing products. Pressing this button will
start the Primary labeling (if it is online) and
after the Off Distance, the Secondary stops.
Crossover Setup
1) Turn on the Encoder Option in the
Product Setup Menu.
2) With the Option turned off on both
Applicators, label some products to
make sure the Applicators are setup
properly and Label Placement is
correct. When finished, turn the
Option on in both Applicators.
3) Select the each Applicator to be either
the Primary or the Secondary
Applicator. The green lamp indicates
the current setup.
4) If the Applicator is going to be the Secondary, measure the distance between the two application points,
subtract ½ inch and enter this as the “On and Off Distances”.
5) Bring both Applicators online and begin labeling products. Take the Primary offline the Secondary
should label the first unlabeled product. If it started labeling too soon, increase the ‘On Distance”. If
labeling started too late and a product was missed, decrease the “On Distance”.
6) With the Secondary labeling and the Primary online, press the “Transfer” Key on the Secondary
Display. The Primary should start labeling while the Secondary continues to label products between
the two Applicators. When the first labeled product from the Primary reaches the Secondary, the
Secondary should stop labeling. If the Secondary continues to label, lower the “Off Distance” value.
If it stopped too soon, increase the value.