CTM 360a series, Руководство по техническому обслуживанию и ремонту

Страница: 42 / 176

360a DISPLAY
3-30
SPECIAL OPTIONS SECTION (cont’d)
The inertia of the label roll and the system components, friction, and dancer arm spring tension are all
factors in determining how much torque is required to operate at a given Web Speed and
Acceleration/Deceleration rate. The factory should be consulted if you feel the default values need
changed.
Current
– The High and Low Current setting can be changed here. The High Motor Current setting should
be set at 7 amps for a standard motor. If more than 7 amps are required, contact the factory since it is likely
that another problem exists that they can help diagnose.
The Drive is able to supply non-standard
motors with up to 12 amps of current. Contact the factory for information concerning non-standard
motors. The Low Current setting will rarely change. Consult factory before adjusting this value.
Customer Password - Here an operator can
setup their own Password that applies to all
password-protected areas except the Special
Options Menu. The Password from the
factory is “1800” but the new Password can
be anything from 1 to 9999;
zero (0) leading
numbers will not be supported. If the
Password was changed and no one can
remember what it is, the operator can touch
the upper right hand corner of the power-up
software screen. Then they can select the
Restore Password key from the Factory
Default Menu to reset the password to “1800” (see page 3-30).
Software Version - This screen tells the operator the software version and date for the program. If the
program is custom, additional feature information is provided in a Submenu.
No Labels Found Count - This is the number of consecutive missing labels on the liner before a Critical
Alarm occurs.
Encoder Deadband
– Some Encoders at idle will send pulses to the Applicator due to vibration at the
Encoder. This gives the operator the ability to set a value that if the velocity is equal to or less than, the
Applicator will ignore it.
Placement To Time – This Option only
appears if the Applicator Type is a Merge and
the Encoder is turned on. You will use this
when labeling in a Wrap Station that is
equipped with an Encoder. This way the
Applicator will dispense its label at the Encoder
Speed but the start of the labeling sequence will
not be dependent on the Wrap Belt position but
instead will be time-based. This is good since
the belt runs at a different speed than the
conveyor, which is handling the product.