CTM 360a series, Руководство по техническому обслуживанию и ремонту

Страница: 19 / 176

360a DISPLAY
3-7
LABEL SETUP (cont’d)
Label Sensor -Pressing this key will bring up
the Label Sensor Menu. This is where the
sensitivity of the Label Sensor is setup. The
operator will have two choices:
Auto Teach
Manual Teach
Manual Teach
In the Manual Teach Mode, the operator will
first choose whether they want to trigger on the
leading or trailing edge of the label. The only
reason for changing edges occurs when the
Label Stop is either too small or too close to the
Label Length. After selecting an edge detection
mode, the Display will provide operator
instructions at the bottom of the screen. For
example, if leading edge is selected, the Display
will prompt the user to move the label and liner
under the Label Sensor and press the Teach Key
on the screen. After a couple of seconds the user is prompted to move the liner under the sensor. Move the
label stock by turning the Drive Roller to place the label gap under the sensor or remove a label. Again the
operator will press the Teach Key. After a couple of seconds the process is finished. The operator can
return to the Label Setup Menu by pressing the “Prev Menu” Key.
Auto Teach
The Auto-Teach function not only sets the
Label Sensor Sensitivity but also calculates the
Label Length and Label Stop values. When the
Auto-Teach function is selected, the operator is
prompted to move the label gap under the
sensor. Pressing the Teach Key causes the
Applicator to dispense 10 inches of labels while
setting the Label Sensor Sensitivity. A Bypass
Key is provided to skip the sensitivity setup for
instances where the sensitivity is known to be
correct or when a Clear Label Sensor is
installed. Following the sensitivity setup, the
operator is prompted to move the label to the Label Stop Position and press the Teach Key. Three labels
are dispensed while calculating the Label Length and Label Stop values. If the Multi-Panel Option was on,
an extra screen appears instructing the operator to move a label to the Peel Edge to allow the controller to
calculate the Short Feed Distance. This will be discussed in more detail in the Applicator Setup section.
NOTE: The Label Sensor output lamp will be a light blue when the sensor is on. If the sensor is set
to “Leading”, the light will be on when the label is under the sensor. If “Trailing”, the light will be
on when the gap is under the sensor.
NOTE: See SPECIAL OPTIONS section for information regarding the Label Sensor Model setting if
the Applicator is not responding correctly to label teach routines.