CTM 360a series, Руководство по техническому обслуживанию и ремонту

Страница: 68 / 176

PRODUCT SETUP PROCEDURE
7-2
OPTIONAL PRODUCT SENSOR SETUP
(Banner S18SN6FF50)
This Sensor is an 18mm barrel type with a
50mm far limit cut-off. This means it will see
objects that are less than 2” away and ignore the
rest. There is nothing to adjust on the sensor
except the physical position.
Sensor wiring determines whether the product
detect will be setup for Leading or Trailing
Edge. The #2 terminal in the Product Detect
Plug at the end of the Sensor Cable is for the
Output of the Sensor. The black wire is for
Leading Edge and the white wire for Trailing
Edge.
LABEL PLACEMENT
When a Product Detect Signal is received, the product must travel the “Label Placement” Time or Distance
before the Applicator will apply a label. Label Placement Value gives you the ability to adjust where the
label is applied on the product.
More Label Placement = label moves back on the product
Less Label Placement = label moves forward on the product
Label Placement can be changed from the Main Menu or the Product Setup Screen.
DETECTOR LOCKOUT
The Product Detector Lockout function is used if more than one Product Detect Signal is generated per
product. If the Encoder is on, Detector Lockout is in inches; if no Encoder then it is in seconds. The
Lockout starts at the beginning of a labeling sequence and the Applicator will ignore Product Detect
Signals until the Lockout Time or Distance is finished.
To add Detector Lockout go to the Product Setup Menu and change the Detector Lockout Value. Refer to
page 3-17 of this Manual for more information.