CTM 3600-PA, Руководство по техническому обслуживанию и ремонту

Страница: 142 / 187

PRODUCT SETUP
Optional Product Sensor Setup (Banner S18SN6FF50)
This sensor is an 18mm barrel type with a 50mm far limit cut-off. This means it will see objects
that are less than 2” away and ignore the rest. There is nothing to adjust on the sensor except the
physical position.
Sensor wiring determines whether the product detect will be setup for leading or trailing edge.
The #2 terminal in the product detect plug at the end of the sensor cable is for the output of the
sensor. The black wire is for leading edge and the white wire for trailing edge.
Figure 24 (optional product detect)
Product Detect Sensor Position
Before going through this section. Make sure the extend and retract times properly set up.
Power the applicator up, turn the air on and send label formats to the printer. Position the product
detect sensor about 6 inches upstream of the extended swing arm. Set the #1 label placement to
0.000 and turn the conveyor on. Put a product on and watch when the label is blown off the label
pad. If the product hit the label pad before it retracted, move the product detect up stream more.
If it retracted too soon, move the sensor downstream. Ideally the label will be blown onto the
front of the product and retract without ever touching the product.
Now look at the position of the label on the side of the product. If it’s be applied too late,
decrease the #2 label placement. If it’s been applied too early, increase the label placement. If
the #2 label placement is too low compare to the cycle time of the first half of the labeling
sequence, a warning will be displayed saying “Label Rate Warning”. If you can’t increase label
placement or reduce the time of the first half of the labeling sequence, then slow down the
product.
b6-3