CTC Parker Automation PowerStation P1, Руководство пользователя, Страница: 70 / 86

Resolving Common Problems
62
P1 PowerStation User Guide
5. Check the PC/104 adapter, if installed. Remove the adapter, and power
cycle the unit. If the LED comes on, the PC/104 card was bad.
6. If the problem persists, contact your CTC equipment supplier or
CTC’s technical support for assistance.
Resolving Problems After Powering the Unit
This section lists some possible problems and solutions that may occur
after you power up the PowerStation. The problem is listed first followed
by a list of possible solutions. Begin with the first one, and continue
through the list until you have solved the problem or reached the end of the
list.
After power up, the screen appears to be blank or very dim.
1. Check to see if the power switch is in the On position and the LED
Power indicator on the front of the PowerStation is lit.
a. If the PowerStation appears to be operating correctly, adjust the
contrast of the display by adjusting the potentiometer on the back
of the unit next to the power switch.
b. If the PowerStation does not appear to be operating correctly,
power cycle the unit.
2. Replace the backlight by following the procedures found beginning on
page 55.
3. If the problem persists, contact your CTC equipment supplier or
CTC’s technical support for assistance.
After power up, the DOS prompt is displayed instead of the PowerSta-
tion Shell MAIN MENU.
1. If the PowerStation appears to be operating correctly otherwise, reboot
the unit.
2. The AUTOEXEC.BAT file may be corrupted or has been modified.
See Resolving AUTOEXEC.BAT and CONFIG.SYS problems on
page 59 for information about correcting this problem.
3. If the problem persists, contact your CTC equipment supplier or
CTC’s technical support for assistance.
StockCheck.com