CSrental B500, Руководство пользователя

Страница: 7 / 20

1
2
Starting up
Carefully loosen the underneath of the housing, e.g.
with a screwdriver. Replace the batteries (MN 1500
LR6, 1,5 V AA).
m Make sure the poles (+/
–) are inserted cor-
rectly.
Press the small black test knob to check the trans-
mission function (the green test diode should light
up). Please attach it to a dry, well ventilated place
such as a ceiling or a wall and make quite sure it is
not exposed to any direct sunlight. (The calibration is
factoryadjusted to 2%)
14. Coding the radio sensor system
Coding the sensor
These appliances are coded in the factory, but if two
or more are used in direct proximity to one another
(i.e. less than 50 metres apart) a different coding may
be necessary.
For each slide control there are only two positions:
„ON”= up and „0FF” = down, which give 16 possible
combinations. Please note: each appliance and its ra-
dio sensor (a + b) must have the same coding.
You have the option here of controlling a number of ap-
pliances in one room from one sensor, with all of them
(Radio frequency 435 MHz)
13. Radio-sensor-system
a) Device circuit board B 500
b) Radio sensor circuit board