CSI GamaJet V, Руководство пользователя

Страница: 15 / 49

13
© Gamajet Cleaning Systems, Inc. 10/24/01
2.3.4.8 Reassembly
Install the Rotor Shaft Lower Bearing #13 if it was removed. Before
pressing the Bearing, be sure to clean the bore and remove any burrs
resulting from Bearing removal, lubricate the outside of the Bearing and
press it in until the flange is fully and flush-seated against the Gearbox
Nose #14.
Install the Output Pinion Seal #12 with its spring side facing towards the
Rotor Shaft Lower Bearing #13 until its flange is fully and flush-seated
against the Gearbox Nose. Reinstall the Idler Gears #16 and Idler Gear
Thrust Washers #15 so that the Thrust Washers are at the side of the hole
with thread. Refer to the Exploded View of the Gamajet V for a pictorial
illustration of the location of these Washers. Then screw the Idler Shaft
#18 into the Gearbox Nose.
Replace the O-ring #19 if necessary and then press the Rotor Shaft Upper
Bearing #20 into the Gearbox Nose.
2.3.5 STEM #24
2.3.5.1 Inspection
Inspect the Stem #24 for damaged threads and wear. The Stem should be
replaced if it is grooved in the seal contact area or bent or its threads are
damaged.
2.3.5.2 Gearbox Nose Screw O-ring #23
Remove the four O-rings #23 from their seats around the screw holes in
the bottom of the Stem and discard them. These should always be
replaced with new ones whenever the machine is disassembled.
2.4 REASSEMBLY
Note: All parts must be cleaned thoroughly before reassembling. Any deposits
remaining on the parts can cause difficult disassembly the next time the Gamajet needs
servicing.
Apply a dab of a Teflon-based anti-seize compound to all threads (especially the threads
on the Stem ) when reassembling; this will prevent galling of threads and ease any future
disassembly.
Whenever lubrication of parts is required for assembly, lithium-based soap grease
(Calypsol SF 3-097) is satisfactory.