Crystal Vision
Using the front control panel
TANDEM HD-20 User Manual R1.4
34
24/05/2007
Headphone Monitoring
A powerful 12-source stereo monitoring bus provides audio monitoring at the card edge
headphone socket.
Notes: Odd channel numbers will appear in the left headphone with the corresponding
even channels appearing in the right.
F (front) and R (rear) indicate a sub-PCB and its location when fitted to the TANDEM HD-20
motherboard.
Menu
Comment
Monitoring menu
Press F4 to enter the Monitoring Headphone configuration menu.
Card edge stereo
headphone routing
The monitoring outputs for the board edge headphone socket are
selected in stereo pairs.
A12, A34, B12, B34, R12, R34, F12, F34, C12, C34, D12 & D34
Note: If output sub-PCBs are fitted B-F will copy C-D.
Preset menu
Up to sixteen setups may be stored for the board and recalled either from the board control,
active front panel, Statesman or through the use of external GPIs. Presets store board setup
data including operating mode and option card status. If at any time a sub-PCB is changed for
a different type, i.e. from an input type to output type, any previously saved preset
configurations will become invalid. The presets are numbered 1-16.
Note: Care should be taken when storing presets that the desired configuration is not changed
by any external input prior to saving.
Menu
Comment
Save and recall
Presets 1-16
To save a user configuration from the active control panel.
From the Home menu Press F3 to select the preset menu.
Press F1 and rotate SCROLL to find the required preset location.
Enable GPI
control of presets
Selecting Enable allows the recall of previously saved user
configurations via GPI inputs 0-3.
To enable GPI control press F1 to toggle between On and Off.
Press ENTER to select.
