Crystal Vision
Using the active control panel
SW808 User Manual R1.8
16
22/12/2008
4 Using the active control panel
This operational guide assumes that the panel has been set up according to the Panel setup
procedure described in the Crystal Vision Controls Panel manual.
Note:
It is
ESSENTIAL
that the Panel set up procedure is followed and any old or unknown
passwords cleared prior to using the panel for the first time.
At power up, the two-line 20-character screen will display ‘Crystal Vision’ followed by
the firmware version number for the control panel. All eight control panel key LEDs will
illuminate.
The Crystal Vision control panel start up display
'Control Panel' then briefly replaces the version number display.
If the control panel firmware has been updated for Statesman control, Statesman Mode
will be entered and the message, ‘Press CAL to Exit’ will be displayed and the CAL LED
will light.
Statesman mode is entered by default
To continue with control panel operation or configuration, press the ‘CAL’ key once. A
second press of the ‘CAL’ key will return to Statesman control.
The control panel will display the name of the card that first responds to the polling
request together with its location number.
The location number consists of the frame number plus the card position in the frame.