Crystal Vision
The SW808 Controller panel
SW808 User Manual R1.8
10
22/12/2008
Multiple routing
Multiple routing can be performed by creating the required destination-source pairs
before pressing the TAKE button. The destination buttons will flash to show that they
have routing waiting for a take. To confirm the routing press the TAKE button and the
selected routing assignments will all be updated simultaneously.
This is similar to establishing a single crosspoint except that instead of pressing TAKE
immediately, further destination-source pairs are created first.
Note:
The last destination button pressed does not flash.
Setting up multiple routing:
•
Press the destination and then the source for each crosspoint assignment
required in turn – destination buttons flash
•
Press TAKE to confirm the routing
Using salvos
Up to sixteen salvos may be recorded and recalled from the SW808, Statesman, the card
edge control or by external GPIs. Like macros, salvos do not store board setup data,
switching mode or reference selection.
Salvos can be created from the controller panel; by setting up multiple routing and
pressing SAVE instead of TAKE. All the source and destination buttons will flash to
indicate that a memory location needs to be selected. The source buttons 1 – 8 represent
Salvos 1 – 8, and the destination buttons represent Salvos 9 – 16. Select a memory
location and then press SAVE to confirm.
Creating a Salvo:
•
Set up the required routing
•
Press SAVE – all source and destination buttons flash
•
Choose a source/destination button for the Salvo - SAVE will flash
•
Press SAVE to confirm the choice
To recall a Salvo press RECALL, select a memory location and then press RECALL
again to confirm, or any other button to cancel.
Recalling a Salvo:
•
Press RECALL – all source and destination buttons flash
•
Choose a source/destination button with a previously saved Salvo - RECALL
will flash
•
Press RECALL to confirm the choice
Notes:
Salvos are similar to Macros in that only those crosspoints in the Salvo are changed. All
other crosspoints will remain as they were before the Salvo was recalled.
The operation of the panel described here is based on panel software version 4.01.