Crystal Vision
Card edge operation
SW803 3G User Manual R1.4
10
01/09/2016
Reading card edge LEDs
Card edge LEDs may be used in conjunction with status information from any connected
remote status panel display or from Statesman if available.
Refer also to the trouble-shooting chapter for more help with solving problems and
monitoring status information.
The following table summarises the card edge LED functions and colours:
Name
LED
Colour
Function when ON
Function when Off
IN 1
Yellow
Input 1 present
Input 1 not present
IN 2
Yellow
Input 2 present
Input 2 not present
PSU
Green
Good power supply (PSU) rails
One or more of the monitor
supplies is out of specification
Yellow
Not currently supported
IN3
Yellow
Input 3 present
Input 3 not present
IN4
Yellow
Input 4 present
Input 4 not present
IN5
Yellow
Input 5 present
Input 5 not present
IN6
Yellow
Input 6 present
Input 6 not present
IN7
Yellow
Input 7 present
Input 7 not present
IN8
Yellow
Input 8 present
Input 8 not present
3.3 Navigating card edge menus
To access the card edge menu system proceed as follows:
•
Press the up-arrow [
] until a top menu category is reached
•
Rotate the SCROLL control until the desired menu category is found
•
Push ENTER to enter the sub menus of that category
•
Rotate SCROLL to select a sub menu
•
Push ENTER to select the desired function. Selection will be indicated by the text
being displayed in
italic
text
•
Rotate ADJUST to make the desired change to the selected parameter. The display
brightness will flash slowly to indicate that a change has been made and requires
confirmation
•
Push ENTER to action the change. The display will cease flashing
•
Use the up-arrow [
] and SCROLL control to navigate to further menus
Note:
The displayed menu brightness will flash slowly if confirmation of a change is required.