5 - 14
Hot Tank Heater Band Replacement
Note: Begin with the hot tank assembly removed from the dispenser (Figure 5-7-1).
1. Remove the bolt that tightens the heater band onto the hot tank (10mm wrench) (Figure 5-7-2). Turn
the heater band until the opening lines up with the stainless J tube and pull down to remove completely
from the hot tank (Figure 5-7-3 and 5-7-6).
2. Install the new heater band by following the steps above in reverse order, ensuring that the wire ter-
minals are located near the top of the heater band (Figure 5-7-7). Align the opening in the heater band
directly below the sensor and limiter, reinstall the bolt and tighten to 34.71 lbf.in (Figure 5-7-8).
3. Refer to the hot tank replacement procedure for installation instructions.
Figure 5-7-2 Figure 5-7-3 Figure 5-7-4 Figure 5-7-5 Figure 5-7-6
Figure 5-7-7 Figure 5-7-8
SECTION 5: Electrical Component
Diagnosis and Replacement
Notice:
The information and/or procedures presented in the following demonstration(s) should be performed by a trained Water Cooler
Service Technician only.
Never attempt to service or repair a water cooler while it is plugged into any power supply.
Prior to any service or repair of the water cooler, ensure that the water has been completely drained from the system.
Figure 5-7-1
