4 - 1
Install Base Plate
1. Stand cooler upright on flat, smooth surface floor.
2. Align side plate with base (Figure 4-1-1), and slide into base to locked position. (Figure 4-1-2
and Figure 4-1-3). The side plates are inserted so that the inner faces mount flush in the rear of the
cooler. There will be an open triangular area in the front.
3. Repeat for opposite side. (Figure 4-1-4 and Figure 4-1-5)
Figure 4-1-1
Figure 4-1-3
Figure 4-1-4
Figure 4-1-5
SECTION 4: Cabinet Panel Removal and Installation
Notice:
The information and/or procedures presented in the following demonstration(s) should be performed by a trained Water Cooler
Service Technician only.
Never attempt to service or repair a water cooler while it is plugged into any power supply.
Prior to any service or repair of the water cooler, ensure that the water has been completely drained from the system.
Figure 4-1-2
