CruzPro MaxVu110, Руководство пользователя, Страница: 20 / 68

Page 20
Turning Alarms ON/OFF
To “arm” the alarms, press and hold the
$
key 1/2 second. The Bell symbol
will be displayed when the alarms are “armed”. To disable the alarms press and
hold the
%
key for 1/2 second. Any press between 1/2 and 2 seconds will
work. A press of less than 1/2 second or longer than 2 seconds will be ignored.
Setting High and Low Alarm Values
To View and/or Set the High Alarm value for any of the five current digital dis-
plays and bar charts, press and hold the
$
key for ten seconds (until you hear
a long beep). To View and/or Set the Low Alarm value for any of the displays
press and hold the
%
key for ten seconds. The alarm value, display identifier
(1, 2, 3, L or r) and the word “HiAL” or “LoAL” will be displayed as shown in
Figure 21. Quick press the
&
key to select the desired display identifier (1, 2,
3, L or r). Press and hold the
%
and
$
keys to change the alarm value. Press
the
&
key for 1 second (until the long beep) to accept the new alarm value, save
it to memory and leave the Alarm Editor mode.
To prevent confusion, the High and Low alarm values are unique for each Data
Source (i.e. RPM or Fuel level, etc.). For example, if you change the high alarm
value for RPM in one display configuration, then the high alarm value for RPM
will automatically change for each display configuration where RPM is displayed.
Be sure to read the warnings about alarms in the Important Notes and
Figure 21 - Alarm Editor
Editing the Hi alarm
for display #3