Crow PowerWave 8, Руководство пользователя

Страница: 9 / 22

9
Operation
How to Arm the System before Exit
•
Preparing the System for Arming
Verify that the green <Ready Byp> indicator is lit .This indicator is lit only when all zones
are closed (all doors, exits and windows are closed and motion in the protected area is
restricted or bypassed) , the system is ready to be armed. If the green <Ready Byp >
indicator is not illuminated, the zone LED 1 to 8 is lit displays the open zones .
Close open zones, or bypass them . Bypass any zone you cannot close , the <Ready
Byp> indicator flashes indicating bypassed zone(s) . For details see page 9.
Note : Bypassed zones are not protected.
•
Arming the System
Before leaving premises the system has to be armed.
When the system is Ready , indicator is lit , enter user code and then < ENTER > to arm
the system.
There is a exit delay prior to the system being armed. During this delay time, a slow
beeping is heard to indicate that the system is not armed yet and reminds you to leave the
protected area.
The A indicator lights up to indicate that the system is armed.
(The indicators may go out few seconds after exit delay expired , depending on the
installer's setting).
If you must disarm the system during the exit delay, press < ARM >.
•
Quick Arm
(When enabled by the installer)
When the system is Ready , press < ARM > to arm the system.
The A indicator lights up to indicate that the system is armed.
During exit delay time, a slow beeping is heard to indicate that the system is not armed yet
and reminds you to leave the protected area..
• Disarming the System
Enter User’s code and press < ENTER >. The A indicator goes off to indicate that the
system is disarmed.
• Stopping Alarms
In case of alarm condition , Enter User’s code and press < ENTER > to stop alarm any
time.