Crow PowerWave 8, Руководство пользователя

Страница: 10 / 22

10
How to Arm the System when Staying Home
• Arming the System in Stay Mode
This type of arming is used when people are present within the protected area. At night
time, when the family is about to retire , perimeter zones are protected, but not the interior
zones. Consequently, interior movements will be ignored by the system.
When the system is Ready, press <STAY> , enter user code, and then < ENTER >.
The A indicator flashes to indicate that the system is armed in stay mode .
• Quick Stay
When enabled by the installer, press < STAY > to arm the system.
During exit delay you can leave the premises. If you wish to stay or that no one will enter
the protected premises, you may cancel the Entry/exit delay by pressing the <
ENTER >
key. The slow beeping stops and the system is immediately armed.
The A indicator flashes to indicate that the system is armed in stay mode .
(The indicators may go out a few seconds after exit delay expired , depending on the
installer's setting).
•
Disarming the System
Enter user’s code and press < ENTER >, or press < STAY > if enabled by installer.
The A indicator goes off to indicate that the system is disarmed.
How to Arm Partitions
The protected area can be grouped into two separate partitions ( A and B ). The system
can be grouped for User ‘s convenience to separate, in a business environment, the offices
from the warehouse area, or in a private residence, the different rooms of the home, e.g.,
living room, bedroom, etc.
To arm partition A enter user code for partition A
To arm partition B enter user code for partition B,
Note : to arming partition with code see page 7 “How to arm the system before exit”
During exit delay you can leave premises. At the end of the procedure the A indicator or
the B indicator lights up to indicate that the partition A and/or B is armed.
(The indicators may go out after a few seconds, depending on the installer's setting).
To disarm partition, see "Disarming the System".