Crossfire 190CUB, Руководство оператора

Страница: 14 / 18

12
distributor.
For “ 1
st
” it should be the initial checking and process regular checking hereafter 。
12.2. Notices:
11.2.1 Rotation parts: Danger ！
There are high-speed moving parts in the machine.
Stop the machine before Inside check and maintenance
11.2.2 Electric shock Hazard ！
There is high voltage part in working machine.
Stop the machine before Inside check and maintenance
11.2.3. There are some high temperature parts inside of the machine, it’s very dangerous.
① Please stop the machine firstly, and then maintain the inner of the machine.
② The engine cover is still heat after the machine shut down. Please be carefully.
12.3 The fault and removes
（ table 4 ）
Breakdown Analysis Solutions
The
engine can
not start
Motor doesn’t
work,
Or the running
speed is too slow.
Imperfect earth Repair
Starting switch is bad Replace
Starter is bad Replace
Lead short circuit Repair
The starter running,
But not start-up.
Lack fuel Filling Fuel
The hole on the fuel oil filter is blocks
up
Clean or replace
Take off the air is bad Let out the air
Fuel cylinder type winding not
working
Examine the fuse. If it
breaks off, please replace a
new one. Check and replace
the cylinder type winding
Under low
temperature The
machine cannot
start
Fuel frozen Use winter oil
Some frozen water in oil system.
Heating. Discharge the
water in the fuel tank , fuel
filter and inner of fuel
pipeline inner
Poor air discharge in oil pipe Let out the air
The machine auto-stop, and the
running speed can not reach the
standard.
The hole on the fuel oil filter is
blocked up
Replace the accessories of
fuel filter, after cleaned,
please replace the filter
Air filter is blocks up
Replace the element of air
filter
Machine Stops because oil
pressure comes down
Lack oil Filling oil
Oil pressure switch is bad Replace switch
The hole on the engine filter is blocks
up
Replace filter
Can not reach the highest
running speed
Adjuster pole location is incorrect Adjust （ step on the gas ）
There are air interfused the fuel pipe Let out the air
Unload running speed is too Adjuster pole location is incorrect
Adjust
（
slow down the
accelerograph ）