Crivit 327402_1904, Руководство по эксплуатации

Страница: 10 / 86

12
• Do not expose the batteries to extreme
conditions (e.g. radiators or direct sunlight).
Otherwise there is an increased risk of leakage.
• Batteries can be life-threatening if swallowed.
Therefore, always store them out of reach of small
children. Medical attention must be sought imme-
diately if a battery has been swallowed.
Danger!
• Handle damaged or leaking batteries with extreme
caution and dispose of them properly as soon as
possible. Wear gloves when doing so.
• If you come into contact with battery acid, wash
the affected area with soap and water. If battery
acid gets in your eye, rinse it with water and seek
medical attention immediately!
• The connection terminals must not be short-cir-
cuited.
Replacing the batteries
CAUTION! Observe the following instruc-
tions to avoid mechanical and electrical
damage.
Danger!
There is a battery LR03 in the item. You can
replace the battery if it stops working.
1. Raise the display on the side, and carefully
remove it. The battery is at the back of the display.
2. Slide the battery carefully out of the battery
casing and replace with a new one.
Note: Make sure that the battery is inserted
properly and completely in its casing.
3. Insert the display and the cable connections
into the casing once again.
Note: Make sure that the display is correctly
inserted in the casing once again.
Assembling the stepper
Step 1:
Insert both plastic feet into the pipe on the back of
the frame. The ribbed contact surfaces lie on the
floor and the sharp ends point backward (Fig. C).
To anchor it, a self-tapping screw is inserted into
the pre-drilled hole on the underside of the frame.
Note:
Make sure that the pre-drilled hole in the
frame and the plastic foot are placed exactly on
top of each other.
Step 2:
The adjustable screw is screwed into the thread on
the front of the stepper.
With the help of this screw, you may adjust the
step height of the tread surfaces.
To increase the step height, turn the adjustable
screw in a clockwise direction. To lower the step
height, turn the adjustable screw in an anticlock-
wise direction.
Step 3:
Remove the computer from the stepper by pulling
it upwards.
Place the supplied battery in its appropriate com-
partment on the underside of the computer. Ensure
that the polarities are correctly aligned.
Connect the computer to the connector on the cas-
ing and insert it once again. Make sure that the
cable does not get pinched during this procedure.
Step 4:
Observe the maximum stretch length of
the straps.
The shorter the straps, the greater the effort
expended.
• Shorten the straps by locking the rubber hose
with the safety ball into place (Fig. B).
IMPORTANT! Make sure not to shorten
the straps too far. Do not go past the
“MIN.” marking!
• Hook the metal hook into the eyelet on the
stepper frame and screw in the fastener on the
hook tightly (Fig. D).
Important! Before training, check that
the straps are securely fitted, and that
the hook is safely and tightly screwed in.
Caution! The eyelets are secured for ten-
sile loads upwards only, and may not be
subjected to transverse loads. There is a
risk of injury, or damage to the stepper.
When you are not training with the straps, unhook
them from the eyelets to avoid tripping over them.
Check whether all screws and nuts are securely
tightened.
GB/CY