Change the Default Scene
The Zūm keypad buttons recall predefined scenes (light levels) that are
stored in the load controllers. The default scenes are On (Scene 1) which
sets the loads at 90%, Scene 2 which sets the loads at 50%, and Scene 3
which sets the loads at 10%. Load controllers can save up to 16 scenes.
There are several methods of changing the default scenes. Use the
method that matches your needs.
l
End-User Method: Change the light levels for Scene 2 or Scene 3 when
all load controllers are easily accessible. On (Scene 1) cannot be
changed. This method cannot be used on 2-button keypads.
l
Manual Method: Change the light levels for On (Scene 1) in addition to
Scene 2 or Scene 3 when all load controllers are easily accessible.
l
Remote Method: Change the light levels for On (Scene 1), Scene 2, or
Scene 3 when a load controller is not physically accessible.
NOTES:
l
A dimmer lowered to 0% will turn the dimmer off when the scene is
recalled.
l
A load controller that is not bound to the keypad cannot be part of
the scene.
End-User Method
End-User method to change the scene for Scene 2 or Scene 3:
1. Set all load controllers that are bound to the keypad to their desired
light level.
2. Press and hold the SCENE 2 or SCENE 3 button until the LED lights
(about 5 seconds) to save the light levels to the selected button.
Manual Method
Manual method to change the scene for On (Scene 1):
NOTE:
Scene 2 and Scene 3 can also be changed.
1. Enter Scene Setting mode using the keypad that will recall the scene.
a. Press and hold both the top and bottom buttons until the LED
lights (about 5 seconds).
b. Press the top button two times.
c. Press the bottom button once. The LED on the keypad flashes
its LED two times every two seconds to indicate that it is in
Scene Setting mode. Load controllers that are bound to the
keypad flash their LED rapidly.
NOTE:
Scene Setting Mode exits after 5 minutes when
initiated from an ac-powered keypad or 1 minute when
initiated from a battery-powered keypad.
2. Adjust all light levels.
l
Using a dimmer, press and hold the top button to raise the light
level or press and hold the bottom button to lower the light level.
l
Using a switch, press the top button to turn the lights on or press
the bottom button to turn the lights off.
l
Using a J-box load controller, press and hold the TEST button on
the J-box device to cycle-dim the light.
3. Using the keypad that initiated Scene Setting mode, press the ON,
SCENE 2, or SCENE 3 button to save the light levels to the selected
scene button.
17
ZUMMESH-JBOX Series
Quick Start
Zūm™ Mesh Wireless J-Box Load Controllers
