Crestron TPS-ENET, Руководство по эксплуатации и установке

Страница: 7 / 28

Crestron TPS-ENET Ethernet Card for TPS/Tilt Panel
Connector Specifications
Connector Specifications of the TPS-ENET
PORT TYPE SIGNAL(S)
Touchpanel
Interface 40-pin connector Various
Pin 1 TD+
Pin 2 TD-
Pin 3 RD+
Pin 4
Connected to pin 5
Pin 5
Connected to pin 4
Pin 6 RD-
Pin 7
Connected to pin 8
Pin 8
Connected to pin 7
LAN (8-wire
RJ45)
RJ 45 Pinouts
1
8
1
8
Front
Top
NOTE: To determine which is pin 1 on the cable, hold the cable so that
the end of the eight pin modular jack is facing away from you, with the
clip down and copper side up. Pin 1 is on the far left.
Physical Description
The TPS-ENET card, as shown on the next page, is a printed circuit
board (PCB) that is designed to be installed in a specific expansion slot
on the touchpanel motherboard. The card contains a 40-pin connector
that attaches directly to the motherboard and the card is secured with two
mounting screws (supplied with TPS-ENET). An 8-position RJ45 port
(labeled
LAN on the touchpanel) is permanently attached to the
motherboard and is accessible through the connector panel at the rear of
the touchpanel base. The port is used for connection to the Ethernet
(cable is not supplied). The port also contains two light-emitting diodes
(LEDs). The green LED on the left side of the port is a link status LED
and illuminates when the card is connected to a working network. The
yellow LED on the right-side flashes to indicate Ethernet activity.
Operations & Installation Guide - DOC. 6016 Ethernet Card for TPS/Tilt Panel: TPS-ENET
•
3