Crestron TPS-ENET, Руководство по эксплуатации и установке

Страница: 17 / 28

Crestron TPS-ENET Ethernet Card for TPS/Tilt Panel
Accessing the Viewport
4. Refer to the documentation supplied with the host control
system and verify communication.
5. As shown below, select Remote | Remote Console | Connect
from the menu.
Viewport Remote Console Connect
6. From the window, select the appropriate NET ID of the
touchpanel.
7. Observe the Viewport connect to the touchpanel.
Ethernet Setup
Ethernet configuration is only performed via the touchpanel console and
not available through Viewport setup screens. This section contains the
console commands required to setup the TPS touchpanel(s) for Ethernet
operation. To setup the touchpanel for Ethernet operation, perform an
appropriate section of “Obtaining Communication” on page 9 then enter
the desired commands. An example Ethernet setup is described on page
14. When in remote console mode, Viewport will display <TPS at the
command prompt.
Operations & Installation Guide - DOC. 6016 Ethernet Card for TPS/Tilt Panel: TPS-ENET
•
13