Crestron TPS-ENET, Руководство по эксплуатации и установке

Страница: 10 / 28

Ethernet Card for TPS/Tilt Panel Crestron TPS-ENET
NOTE: If the angle of the touchscreen needs to be adjusted, refer to the
latest revision of the TPS-5000 or TPS-6000 Operations Guide (Doc.
5863 or 5864, respectively) for instructions of how to use the touchpanel
position lock buttons. The latest version of the appropriate Operations
Guide can be obtained from the Downloads | Product Manuals section of
Crestron’s website (
www.crestron.com) .
NOTE: The diagrams in this procedure show a TPS-6000 touchpanel
but the steps for installation in the TPS-5000 are identical.
1. If the optional external AC power pack is utilized, disconnect
the plug of the power pack from the touchpanel rear port
labeled 24VDC 2A.
2. To prevent errors when re-connecting, label and disconnect all
cables attached to the touchpanel rear panel ports.
3. If necessary, use the touchpanel position lock buttons to adjust
the touchscreen to the maximum (most vertical/upright) angle.
4. To prevent scratching of the screen, place the touchpanel face-
down onto a padded surface.
5. With one hand, hold the touchpanel base cover in place.
6. Refer to the diagram below. Using a #1 Phillips screwdriver,
loosen and remove the eight screws that secure the touchpanel
base cover.
Remove Touchpanel Base Cover Screws
6
•
Ethernet Card for TPS/Tilt Panel: TPS-ENET Operations & Installation Guide - DOC. 6016