Software
Crestron
Touch The PC Driver
PORT
CONNECTOR to CONNECTOR
DEVICE
PORT
A
1
VGA
DB-15, male
DB-15, male
TPS-IMC-BV
RGB
B
2
RGB
RJ-45, 10-pin
RJ-45, 10-pin
Touchpanel
RGB
C
3
COM
DB-9, female
DB-9, female
Control System
COM
D
NET
4-wire Cresnet
4-wire Cresnet
TPS-IMC-BV
NET
E
2
NET/VIDEO
RJ-45, 10-pin
RJ-45, 10-pin
Touchpanel
NET/VIDEO
1
2
3
REF
CRESNET COMMUNICATION #2 - TILT TOUCHPANEL WITH TPS-XVGA-BV CARD
PC
TPS-IMC-BV
Standard null modem serial cable.
FROM
CABLING REQUIRED
DEVICE
These connections (ref B & E) can be made with the 15-foot Triamese cable supplied with the TPS-IMC-BV if an
audio connection is also desired.
Control System
PC
Standard stranded VGA monitor cable.
TO
TPS-IMC-BV
Cresnet Communication #3 - Lectern Touchpanel with TPS-XVGAL
RGB
INPUT
PORT
RGB CABLE
PC
LECTERN TOUCHPANEL
(OR TPS-TPI) WITH
TPS-XVGAL
CRESNET
WIRING
COM
PORT
CONTROL
SYSTEM
NET
PORT
COM
PORT
VGA
PORT
NET (OR
CRESNET)
PORT
A
B
COMM. CABLE
C
BKL T
MENU
PROFESSIONAL CONTROL PROCESSOR
PRO
2
CRESTRO N
PORT
CONNECTOR to CONNECTOR
DEVICE
PORT
A
1
VGA
DB-15, male
BNC-5, male
Touchpanel
RGB
B
2
COM
DB-9, female
DB-9, female
Control System
COM
C
NET
4-wire Cresnet
4-wire Cresnet
Touchpanel
NET
1
2 Standard null modem serial cable.
PC
A standard stranded VGA monitor cable with DB15F to BNC-5 adapter is required. Both are commercially
available.
Control System
PC
REF
CRESNET COMMUNICATION #3 - LECTERN TOUCHPANEL WITH TPS-XVGAL CARD
FROM
CABLING REQUIRED
TO
DEVICE
2. Proceed to “VT Pro-e Programming” that begins on page 14.
PC to Touchpanel Ethernet Communication
For Touch the PC V2 operation using Ethernet communication from the PC to the
touchpanel, refer to the following two sections, “Cabling Connections” and
“Ethernet Setup.”
NOTE:
To connect the LAN port on the control system and the LAN port on the
touchpanel base directly instead of through an Ethernet hub, use an Ethernet
crossover cable (not supplied).
8
•
Touch the PC Driver
Programmer’s Guide – DOC. 5916B
