Crestron Sonnex SWAMP(I)-24X8, Руководство по эксплуатации

Страница: 34 / 56

Sonnex Multiroom Audio System Crestron
SWAMP(I)-24X8
28
•
Sonnex Multiroom Audio System: SWAMP(I)-24X8 Operations Guide – DOC. 7049E
• Impedance specifies the impedance of a speaker connected to a selected
zone.
• Speaker Protect enables or disables the Speaker Protect function.
NOTE:
As speaker ratings vary greatly across manufacturers, there is no
guarantee that Sonnex Speaker Protect protects against speaker damage in
all situations.
•
Crestron DRC enables or disables the Crestron Dynamic Range Control
function.
•
Global EQ sets the same EQ preset for all zones in the system. Setting this
option overrides any EQ selection that was previously set for an individual
zone.
Enter/Exit the “Zone Setup”
Menu
To enter the “Zone Setup” menu, perform the following procedure:
1. Enter the “Installer Mode” menu as described in “Enter the “Installer
Mode” Menu” on page 26.
2. Enter the “Installer Mode” menu as described in “Enter the “Installer
Mode” Menu” on page 26.
3. Press
q
or
▲
to display Zone Setup and press
ENTER
.
4. To exit the “Zone Setup” menu and return to the “Installer Mode” menu,
press MENU .
Set EQ (Equalization) To adjust a zone’s EQ setting, perform the following procedure:
1. Enter the “Zone Setup” menu as described in “Enter/Exit the “Zone Setup”
Menu” above.
2. Press
ENTER
to select EQ .
3. Press
q
or
▲
to display the zone to be controlled and press
ENTER
. The
EQ screen is displayed.
EQ Screen
Zone 1
EQ Jazz
▲
q
4. Press
q
or ▲ to display the setting to be applied and press ENTER .
5. Repeat for every zone to be adjusted.
6. Press MENU to return to the “Zone Setup” menu.
Set Bass
To adjust a zone’s bass setting, perform the following procedure:
1. Enter the “Zone Setup” menu as described in “Enter/Exit the “Zone Setup”
Menu” above.
2. Press
q
or ▲ to display Bass and press ENTER . A list of zones is
displayed.
3. Press
q
or ▲ to display the zone to be controlled and press ENTER . The
Bass screen is displayed.