Crestron Sonnex SWAMP(I)-24X8, Руководство по эксплуатации

Страница: 22 / 56

Sonnex Multiroom Audio System Crestron
SWAMP(I)-24X8
16
•
Sonnex Multiroom Audio System: SWAMP(I)-24X8 Operations Guide – DOC. 7049E
Connectors, Controls, and Indicators (Continued)
# CONNECTORS,
1
CONTROLS, AND
INDICATORS
DESCRIPTION
19 SETUP
(LED and button)
(1) Recessed miniature push button and (1)
red LED, used for touch-settable ID (TSID) in
conjunction with Crestron Toolbox software
20 GROUND (1) 6-32 screw, chassis ground lug
21 SPEAKER OUTPUTS
(1-8)
(16) 2-pin 7.62 mm 15 A detachable terminal
blocks;
Power amplifier outputs;
Wire Size: Terminals accept up to 14 AWG;
The following outputs can be bridged
together: 1 and 2 (L+R), 3 and 4 (L+R), 5 and
6 (L+R), 7 and 8 (L+R);
Red LED indicates bridged operation
NOTE: Outputs can only be bridged into an
8 ohm load.
1. Interface connectors for NET , ANALOG SOURCES (BALANCED) , and SPEAKER OUTPUTS
ports are provided with the unit.
2. Refer to “Fuse Replacement” on page 25 for additional details.
3. Port on SWAMPI-24X8 is labeled 220-240V~50/60Hz MAX 6A .
4. For connection of the Sonnex Link between the SWAMP-24X8 and each expander, use Crestron
DM-CBL-8G or high-quality CAT5e shielded twisted-pair cable. The maximum cable length using
DM-CBL-8G or CAT5e is 200 ft (61 m) per run. For longer distances, use the S-EXT1-S Sonnex
Link over Fiber Extender (sold separately).
5. If using Cresnet as the control system interface, system expansion is limited to one expander. Support
for more than one expander requires Ethernet as the control system interface.