Isys
®
Wired 5.7 Inch Tabletop Touchpanel
Crestron
TPS-1700
6
•
Isys
®
Wired 5.7 Inch Tabletop Touchpanel: TPS-1700
Operations Guide - DOC. 6223A
throughout the network. Also, for networks with lengthy cable runs, it may be
desirable to add a hub/repeater after only 20 network devices.
Identity Code
Every equipment and user interface within the Cresnet system requires a unique
Cresnet identity code (Net ID). These codes are two-digit hexadecimal numbers from
03 to FE. Refer to “Select Interface” on page 7 for instructions on setting the unit’s
Net ID. The Net ID of the unit must match the Net ID specified in the SIMPL
Windows program. Refer to “Setting the Net ID in Device Settings” on page 12 for
details of the SIMPL Windows procedure. The Net ID is used when the touchpanel is
wired directly to the control system during uploading a Crestron VisionTools
®
Pro-e
(VT Pro-e) project or upgrading the touchpanel firmware.
Configuring the Touchpanel
NOTE:
The only connection required to configure the touchpanel is power. Refer to
“Hardware Hookup” on page 9 for details.
MAIN MENU
This menu can also be obtained via
digital reserved join number, 17242.
To configure the unit, it may be necessary to access a series of setup screens prior to
viewing run-time screens that are loaded into the touchpanel for normal operation.
The MAIN MENU for configuring the touchpanel appears when a finger is held
(approximately five seconds) to the touchscreen when power is applied.
Upon entering SETUP MODE, the MAIN MENU, shown to the left, displays four
buttons:
Touch Screen Calibration
,
Exit and Run Program
,
Setup
, and
Diagnostics
.
Selecting
Exit and Run Program
verifies that all of the setup information has been
saved to EEPROM and displays the main page that has been programmed into the
touchpanel. The remaining buttons on the MAIN MENU open other menus, which
are discussed in subsequent paragraphs.
Calibration Menu
CALIBRATION MENU
Calibration of the touchscreen is required if the active touch area of a button does
not coincide with the button's image. Select the
Touch Screen Calibration
button to
display the CALIBRATION MENU, as shown to the left. The CALIBRATION
MENU offers the choice to initiate calibration with the
Perform Calibration
button
or return to the previous screen with the
Return
button. Choose an option by
touching the appropriate button.
If you need to calibrate the touchpanel, the screen displays the message "Touch
Upper Left" centered on the panel with a cross hair in the upper left corner. Touch
the cross hair to initiate calibration. Another message, "Touch Upper Right", appears
with a cross hair in the correct corner. Touch the cross hair. A final message, “Touch
Lower Right”, appears with a cross hair in the correct corner. Touch the crosshair to
finish the calibration and return to the MAIN MENU.
NOTE:
When touching each crosshair during calibration, be as accurate as possible.
Use the tip of a capped pen or the eraser end of a pencil. To cancel calibration and
return to the CALIBRATION MENU without saving calibration data, create a
calibration error by touching the screen in an area that is opposite from the instructed
area.
Содержание Isys TPS-1700
Страница 1: ...Crestron TPS 1700 Isys Wired 5 7 Inch Tabletop Touchpanel Operations Guide...
Страница 4: ......
