Crestron DigitalMedia DM-NVX-350, Руководство по эксплуатации продукта

Страница: 75 / 96

Product Manual – DOC. 7839M DM-NVX-35x(C) Encoders/Decoders
•
69
Network Port Selection
Network port selection enables network traffic to be managed and segregated based on
traffic type. Internal VLANs are used to route different traffic types to specific external
Ethernet ports, which are assigned to the various traffic types. AES67 or Dante audio
can be separated from the primary video and control network resulting in a dedicated
audio network.
CAUTION: When network port selection is set to Off (default setting), multiple Ethernet
ports cannot be connected to the same Ethernet switch. Doing so will cause a network
loop and bring down the network.
NOTE: If network port selection is enabled, daisy chain configuration is not supported.
To configure network port selection:
1. Click the Settings tab and then click Port Selection.
2. Enable or disable port selection by setting the Port Selection toggle switch in the
On (right) or Off (left) position, respectively. The default setting is Off.
3. If Port Selection is set to On, assign each of the following traffic types to a
specific Ethernet port:
NOTE: For the DM-NVX-350(C) and DM-NVX-351(C), Ethernet ports 1, 2, and 3
are available for use. For the DM-NVX-352(C), Ethernet ports 1 and 2 are
available for use.
•
Management (default setting is port 1)
NOTE: The management port controls the connection to the DM NVX web
interface. Changing the port number will result in losing the connection to the
web interface.
• Video (default setting is port 1)
• Audio/NAX (default setting is port 1)
•
Dante (applicable to DM-NVX-352 and DM-NVX-352C only, default setting is
port 1)
•
USB (default setting is port 1)
4. Click Save Changes to apply the new settings.