Crestron DigitalMedia DM-NVX-350, Руководство по эксплуатации продукта

Страница: 12 / 96

6
•
DM-NVX-35x(C) Encoders/Decoders Product Manual – DOC. 7839M
NOTES:
•
When a DM-NVX-35x decoder is connected to a DM-NVX-35x(C), DM-NVX-
36x(C), or DM-NVX-E30(C) encoder, pressing the SETUP button on the decoder
for less than 10 seconds displays the decoder IP address on the display connected
to the HDMI output of the decoder.
•
When a DM-NVX-35x encoder is connected to a DM-NVX-35x(C) decoder,
pressing the SETUP button on the encoder for less than 10 seconds displays the
encoder IP address on the display connected to the HDMI output of the encoder.
In addition, the decoder IP address is shown on the display connected to the
HDMI output of the decoder.
•
When a DM-NVX-35x encoder is connected to a DM-NVX-36x(C), DM-NVX-
D30(C) or DM-NVX-D80-IOAV decoder, pressing the SETUP button on the
encoder for less than 10 seconds displays the encoder IP address on the display
connected to the HDMI output of the encoder. Both encoder and decoder IP
addresses are shown on the display connected to the HDMI output of the
decoder.
•
When the SETUP button is pressed for 10 seconds, a message appears on the
display stating that the button must be pressed again to change the operating
mode. Pressing the button a second time changes the operating mode from a
receiver (decoder) to a transmitter (encoder) or from a transmitter to a receiver
and reboots the device.
The SETUP button can be used to change the operating mode only if Device
Mode Lock is disabled in the System Setup section under the Settings tab.
For additional information, refer to "Device Mode Locking" on page 70.

RESET: Recessed push button for hardware reset

INPUT SEL: Push button for manual input selection and two bicolor green/amber
LEDs. Green LED indicates that the corresponding input is selected. Amber LED
indicates that the corresponding input is detected but is not selected.

IR 1–2: 4-pin 3.5 mm detachable terminal block;
Comprises two IR/serial ports;
∗
IR output up to 1.1 MHz;
1-way serial TTL/RS-232 (0–5 volts) up to 19200 baud;
Crestron IRP2 emitter sold separately

COM: 5-pin 3.5 mm detachable terminal block;
Bidirectional RS-232 port;
*
Up to 115.2k baud, hardware and software handshaking support

24VDC 2.0A: 2.1 x 5.5 mm DC power connector;
24 VDC power input;
Power pack included

Ground: 6-32 screw, chassis ground lug
∗ Device control via IR and RS-232 requires integration with a Crestron 3-Series or later control system.