Pan/Tilt Camera Head with Control Interface
Crestron
CPC-CAMI
10. Mount the CPC-CAMI with attached camera/lens assembly to the
desired location. Unit mounts on its 3.750 inch (9.525 cm) diameter
base with two ¼-20x3/8” pan Philips head screws, 2.000 inches (5.080
cm) on center (refer to the illustration below).
NOTE:
If longer screws (than the ones supplied) are required to mount the CPC-
CAMI with attached camera/lens assembly, only allow five turns into the unit’s
thread insert. More turns may disable the CPC-CAMI from panning.
CPC-CAMI with Camera/Lens Mounting
Identity Code
Every equipment and user interface within the network requires a unique identity
code (NET ID). These codes are recognized by a two-digit hexadecimal number
from 03 to FE. The NET ID of each unit must match an ID CODE specified in the
SIMPL Windows program. The NET ID of each CPC-CAMI has been factory set to
34, but may be changed from the PC via VisionTools™ Pro-e (VT Pro-e) or
SIMPL™ Windows
.
The method for changing the unit’s NET ID is identical regardless of the software
chosen. Attach the CPC-CAMI to the control system (verify that the software is
running) and complete the following steps to change the NET ID.
1. Disconnect all network devices from the control system, except for the
one CPC-CAMI that needs to have its NET ID code changed.
2. Select
Tools | ViewPort
to open the “Crestron Viewport” dialog box.
3. Select
Functions | Set Network ID
. The software checks the baud rate
and then opens the “Set Network ID” dialog box.
4. Notice the list of current network devices in the dialog box. Highlight
the CPC-CAMI.
5. The NET ID of the CPC-CAMI (default is 34) appears in the box
below the list. Use the scroll arrow to assign another NET ID.
6. When the newly assigned NET ID appears, select the
Set ID
button to
initiate the change.
7. The software responds with a successful message to confirm the new
NET ID.
10
•
Pan/Tilt Camera Head with Control Interface: CPC-CAMI
Operations Guide - DOC. 5726A
