Pan/Tilt Camera Head with Control Interface
Crestron
CPC-CAMI
Leading Operational Specifications of the CPC-CAMI
SPECIFICATION
DETAILS
Operating Speeds
Pan (horizontal) 22.5 degrees/second
Tilt (vertical) 20.0 degrees/second
Maximum Camera/ Lens Load
15 lbs. (6.80 kg) - (balanced)
Preset Recall Resolution
+/- 0.25 degrees
As of the date of manufacture, the unit has been tested and found to comply with
specifications for CE marking.
NOTE:
These devices comply with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) these devices may not cause harmful interference,
and (2) these devices must accept any interference received, including interference
that may cause undesired operation.
Setup
Camera/Lens Mounting
The CPC-CAMI is not orientation sensitive; it is possible to mount the CPC-CAMI
on either rotating disk. However, realize that the height of the two sides to which the
disks are attached are not equal. Therefore, mounting the camera/lens assembly to
the longer side allows for a greater range of motion (assuming that the CPC-CAMI
is directly mounted to a large horizontal surface).
NOTE:
The CPC-CAMI has an identifying mark labeled “FRONT” on the flat
mounting plate. The camera must be mounted facing toward the “FRONT” label in
order to function properly with the camera interface controller. A travel limit of 350
degrees protects the unit from windup of cables.
To ensure best performance of the CPC-CAMI, complete the following mounting
steps in the order presented.
1. Assemble the lens and camera.
2. Position the mounting holes of the camera/lens assembly on the flat
mounting plate. Verify that the lens is facing toward the “FRONT”
label on the plate.
3. Use the supplied 1/4-20 x 1/2” hex head screw to loosely attach the
camera/lens assembly to the flat mounting plate. If necessary, use 1/4”
flat washers (two are supplied).
4. Use a round object, such as a pen or pencil, to locate the fulcrum point
at which the camera/lens assembly most closely balances (refer to the
illustration on the next page). At this location tighten the mounting
screw.
8
•
Pan/Tilt Camera Head with Control Interface: CPC-CAMI
Operations Guide - DOC. 5726A
