Crestron
CPC-CAMI
Pan/Tilt Camera Head with Control Interface
Determining Camera/Lens Assembly Center of Gravity
ROUND OBJECT
1/4-20 MOUNTING
SCREW
FLAT MOUNTING PLATE
CAMERA
LENS
5. Use two 1/4-20 x 3/8” pan Phillips head screws (supplied) to loosely
secure the angled mounting plate to the CPC-CAMI. Verify that the
two pins on the plate align with the slot on the rotating disk.
6. Adjust the vertical position of the angled mounting plate (refer to the
illustration below). An imaginary line through the center point of the
camera/lens assembly total height should pass as closely as possible
through the center of the CPC-CAMI tilt axis (minimize HEIGHT
ADJUSTMENT gap). At this location, tighten the two slotted pan head
screws.
Camera/Lens Mounting
WIDTH CLEARANCE
SOCKET HEAD SCREW
(#8-32 x 3/8") WITH
WASHER (#8)
PAN
PHILLIPS
HEAD
SCREW
(1/4-20 x 3/8")
ANGLED
MOUNTING
PLATE
FLAT
MOUNTING
PLATE
HEIGHT
ADJUSTMENT
CAMERA/LENS
ASSEMBLY
7. Position the camera/lens assembly with flat mounting plate onto the
angled mounting plate and loosely secure the plates with two socket
head screws (#8-32 x 3/8”) and two flat washers (#8).
8. Adjust the in/out position of the camera/lens assembly with flat
mounting plate to accommodate the width of the camera/lens assembly.
9. Crestron recommends a
width clearance
of 1.00 inch (2.54 cm) (refer
to the previous illustration). At this location, tighten the two Allen
screws with the supplied hex key.
Operations Guide - DOC. 5726A
Pan/Tilt Camera Head with Control Interface: CPC-CAMI
•
9
