Integrated Control System
Crestron
CNMSX
NOTE:
If a computer is not hooked up, wait approximately three to four seconds.
-
Release the S
W-R
button.
5d. If the CNMSX responds, proceed to step 5e. Otherwise, do the
following.
-
Remove power from the CNMSX.
-
Depress and hold the S
W-R
button on the CNMSX front panel.
-
Reapply power to the CNMSX.
-
Wait until a message similar to the one below appears in the
Viewport.
Viewport Message
NOTE:
If a computer is not hooked up, wait approximately three to four seconds.
-
Release the S
W-R
button.
5e. Text messages, as shown below, should appear on the
Incoming
window
of the Viewport. If messages do not appear or they are illegible,
verify that the Viewport is set to 9600 baud and repeat steps 5a through
5d. If data similar to that shown below appears, perform steps 7 through
11 in "Obtaining Communications" on page 24 before proceeding to the
next step.
Crestron Viewport – Outgoing and Incoming Window
NOTE:
The exact text received depends on the given CNMSX hardware.
28
•
Integrated Control System: CNMSX
Operations Guide - DOC. 8118B
