Crestron
CN-WP12F and CN-WP12N
Source and Numeric Keypads
Operations Guide - DOC. 5788A
Source and Numeric Keypads: CN-WP12F and CN-WP12N
••
5
4.
As shown below, remove the switch cap to be replaced from the rubber
button actuator. Make sure that the indicator lens of the custom switch
cap is above the LED and install the custom switch cap onto the button
actuator.
Install Custom Switch Cap
VOL
VOL
ON/OFF
MUTE
TAPE
AUX
CD 2
D S S
F M
C D
DSS 2
LED
5.
Position the keypad shell so that the upper-tab faces upwards (as the
switch caps are readable) and lower it onto the keypad PCB and base.
6.
Move the switch caps as necessary to align them into the shell openings
and
gently
squeeze the shell onto the PCB and base until the four
retainer tabs click into place.
7.
Position the keypad and the keypad mounting assembly as shown
below.
Alignment Points for Re-assembly
MOUNTING
ASSEMBLY
UPPER-SLOT
KEYPAD
UPPER-
TAB
KEYPAD
18-PIN
PLUG
MOUNTING
ASSEMBLY
18-PIN SOCKET
VOL
VOL
O N / O F F
M U T E
TAPE
A U X
C D 2
D S S
F M
DSS 2
