PINNACLE ROCK WALL
19652-400 Rev F (05-20)
© Copyright 2004, Creative Playthings, Printed in U.S.A.
Page 7
ASSEMBLY INSTRUCTIONS
Bottom
Spacer Board
Angled Rail
Angled Rail
Top Rope
Board
STEP 12 — Fasten Climbing Rope:
The Climbing Rope Assembly comes pre-knotted on
approximately 12" centers. This is done to prevent the rope
from separating and provide a better grip. DO NOT MODIFY
THE DESIGN OF THIS ROPE. IF THE ROPE IS REPLACED,
IT IS EXTREMELY IMPORTANT THAT YOU MAINTAIN THE
SAME DESIGN AND CONSTRUCTION.
The top end of the Rope MUST be installed through the hole
provided in the Top Rope Board (E) and the hole that was
drilled in Step 9. Pull the Rope through the holes and tie a
knot in the end as shown in the illustration.
Pre-stretch the rope before tieing the bottom end. The bottom
end of the Rope MUST be installed under the bottom spacer
Board and through the hole in the Center Rail. Pull the Rope
through the hole until it is tight and tie a knot in the end as
shown in the illustration.
Check the rope periodically to ensure that it has not loosened.
Tighten the rope when necessary.
WARNING: AT NO TIME SHOULD THE BOTTOM END OF
THE ROPE BE UNTIED OR LOOSE ENOUGH TO FORM A
LOOP. THIS WOULD PRESENT AN EXTREME DANGER
TO YOUR CHILDREN.
Support
Important: Set the base of the Rock Climber
into the ground to the level of the bottom of
the Rope
Ground Level
