PINNACLE ROCK WALL
19652-400 Rev F (05-20)
© Copyright 2004, Creative Playthings, Printed in U.S.A.
Page 3
ASSEMBLY INSTRUCTIONS
STEP 1 — Assemble Bench Step:
Layout the two Bench Supports (G) so that they can be
attached to each end of the Bench Cleat (H), lay the Bench
Seat (F) on top and centered, see illustration.
Fasten the two Bench Supports (G) to the Bench Cleat (H)
using one #8 x 2-1/2" Phillips Head Screw to fasten each
board. Fasten the Bench Seat (F) to the Bench Supports (F)
and the Bench Cleat (H) using seven #8 x 2-1/2" Phillips Head
Screws, see illustration.
NOTE: The Bench Step is used on installation to any
Standard Gym. It is not needed on Skybox installation.
STEP 2 — Attach Bench Step to Playset:
Place the assembled Bench Step along the Rear Wall of your
Playset. Make sure it sits flat against the Rear Wall and the
Floor Boards.
Fasten the Bench Step to the Rear Wall in at least four places,
using #8 x 2-1/2" Phillips Head Screws through the Wall Slats
into the back of the Bench Seat from the back of the Gym.
Fasten the Bench Step to the Floor Boards using four
#8 x 2-1/2" Screws, two in each Bench Support. Screw
through the Floor Board from below into the bottom of each
Bench Support.
NOTE: Some wall slats removed from illustration for
clarity.
Bench Cleat
Bench Support
Bench Seat
STEP 3 — Prepare for Top Rope Board:
Insert a 1/4" Weld Nut into the bottom surface of both Angled
Rails (A). This is to fasten the Top Rope Board (E).
