© Copyright 2004, Creative Playthings, Printed in U.S.A.
PINNACLE ROCK WALL
19652-400 Rev F (05-20)
Page 4
ASSEMBLY INSTRUCTIONS
1/4"
Typical
Top Rope
Board (E)
#10 x 2-1/2" T25
Deck Screw
37-3/4"
Rock Board
Spacer
Board
Center
Rail
5-1/2"
1-1/2"
ideal
Align
Bottom View
Center
Rail
STEP 5 — Attach Center Angled Rail:
Attach the Center Rail (B) to the center of the back of the
boards. Align the bottom of the Center Rail with the bottom
of the two outside Rails. Fasten the Center Rail using #10 x
2-1/2" T25 Deck Screws from the front of the Rock Climber.
Drill a 1/8" diameter pilot hole for each screw.
STEP 4 — Assemble Rock Wall:
Set the two Angled Rails (A) approximately 37-3/4" apart.
Fasten a Rock Board (C) 5-1/2" from the top of the Angled
Rails using four #10 x 2-1/2" T25 Deck Screws. Make sure to
leave enough space for the Top Rope Board. The Rock Board
must be at a right angle to the Rails.
Drill a 1/8" diameter
pilot hole for each screw.
Starting at the top, lay out the remaining Rock Boards and
Spacer Boards (D) in the pattern shown in the illustration,
alternating the direction of the holes in the Rock Boards. Leave
1/4" to 3/8" gaps between the boards. The shaft of a 1/4" Bolt
or 1/4" Weld Nut can be used to gauge the gaps. Use four
#10 x 2-1/2" Deck Screws to fasten each board. Leave off
the Top Rope Board (E), at the top of the Rock Climber, until
the unit is fastened to the gym.
Drill a 1/8" diameter pilot
hole for each screw.
